Safety Operation Rules for Steel Wooden Door Embossing Machine

Operation Rules for Steel Wooden Door Embossing Machine

1, steel doors embossing machine operators must be trained to master the equipment    performance and operational skills before they can operate independently.
2, before the operation, you should first clean up the mold on a variety of debris, wipe    the steel doors embossed pole on any dirt.
3, steel doors embossing machine installation mold must be carried out in the case of power    failure, prohibit the collision start button, handle and foot on the foot switch.
4, installed up and down mold alignment, adjust the mold clearance, do not allow unilateral    deviation from the center, to confirm the fixed after the mold and then test pressure.
5, steel doors embossing machine work before the first start the device idle 5 minutes,    while checking the fuel tank is sufficient, the pump sound is normal, hydraulic units    and pipes, joints, the piston is leaked.
6, start the device pressure test, check whether the pressure to work pressure, equipment,    action is reliable, with or without leakage.
7, adjust the work pressure, but should not exceed 90% of the rated pressure of the device,    test a workpiece, after passing the test and then production.
9, the body pressure plate slide up and down, it is strictly prohibited hands and head into    the pressure plate, mold work site.
11, is strictly prohibited in the pressure at the same time, the work of percussion,     stretching, welding and cutting, bending, twisting and other operations.
12, steel doors embossed machine around not smoking, welding and cutting, fire, shall not     store flammable, explosive items. Do a good job of fire prevention measures.
13, steel doors embossing machine work is completed, should cut off the power, the steel     doors embossing machine hydraulic bar wipe clean, add a good lubricant, the mold, the     workpiece clean, placed neatly.